Simple solar charger circuits are small devices which allow you to charge a battery quickly and cheaply, through solar panels. A simple solar charger circuit must have 3 basic features built-in: It should be low cost. Layman friendly, and easy to build. Must be efficient enough to satisfy the fundamental battery charging needs.
Here is the simple circuit to charge 12V, 1.3Ah rechargeable Lead-acid battery from the solar panel. This solar charger has current and voltage regulation and also has over voltage cut off facilities. This circuit may also be used to charge any battery at constant voltage because output voltage is adjustable.
Place the solar panel in sunlight. Check the battery voltage using digital multi meter. Circuit is simple and inexpensive. Circuit uses commonly available components. Zero battery discharge when no sunlight on the solar panel. This circuit is used to charge Lead-Acid or Ni-Cd batteries using solar energy.
Solar battery charger operated on the principle that the charge control circuit will produce the constant voltage. The charging current passes to LM317 voltage regulator through the diode D1. The output voltage and current are regulated by adjusting the adjust pin of LM317 voltage regulator. Battery is charged using the same current.
Output Voltage –Variable (5V – 14V). Maximum output current – 0.29 Amps. Drop out voltage- 2- 2.75V. Solar battery charger operated on the principle that the charge control circuit will produce the constant voltage. The charging current passes to LM317 voltage regulator through the diode D1.
The above 48V solar battery charger circuit with high, low cut-off may be modified with these specifications by introducing a window comparator stage, as shown at the extreme left of the circuit below. Here the opamps are replaced by three op amps from the IC LM324. The window comparator is made by two of the 4 opamps inside the LM324.