In our case we connect the +ve of the solar panel to the pole of the relay and +ve of the battery to N.O when the battery is connected to the SCC (solar charge controller) the circuit check the battery voltage the voltage is less than or equal to lower limit the current is flows to the battery and battery start charging.
Simple solar charger circuits are small devices which allow you to charge a battery quickly and cheaply, through solar panels. A simple solar charger circuit must have 3 basic features built-in: It should be low cost. Layman friendly, and easy to build. Must be efficient enough to satisfy the fundamental battery charging needs.
It’s a 555 based simple circuits the charge the battery when the battery charge goes below the lower limits, and stop charging when the battery reaches it's upper limit voltage “To make a cheap and efficient solar charge controller” This is the driving circuit of the DIY AUTOMATIC SOLAR CHARGE CONTROLLER. To make this circuit you need 1.
The schematic diagram typically starts with the solar panels, which are the main source of the system’s power. The panels convert sunlight into electricity through the use of photovoltaic cells. The diagram shows how the panels are connected in series or parallel to form an array, allowing for maximum energy production.
Below is the circuit diagram for it. The solar cells positive terminal is connected through the diode to the positive terminal of the 1.2V battery. If the voltage of the solar cell drops below 1.4 volts then with the 0.2V the blocking diode takes there wont be enough potential to charge the 1.2V battery.
If a solar panel that is characterized for 12V is applied with a 6V battery, the maximum current must be reduced to about 0.7A: e.g. battery voltage = 6V, solar panel voltage = 18V. P = (18V – 6V) * 0.7A = 9.6W. In this case, the solar panel power may not exceed 10W. When charging, the heat sink normally runs warm.