Put the battery into the product and use it normally until the battery is too low to turn on at all. Activation process 2: The first time you charge, it is best to use the original charger to charge, and it is better to turn off the charge.
Generally, the battery has the following activation process: Activation process 1: The lithium battery that has just been used generally has remaining power, so do not charge it at this time. Put the battery into the product and use it normally until the battery is too low to turn on at all.
To maintain a car battery, you will need a few tools: a voltmeter or multimeter to give readout of a car battery's charge level in volts (v) and amperes (A, mA). A wrench or socket to rotate in a circle and use to torque terminal posts into proper position. A battery cable wrench or pliers to strip battery cable clamps and replace. Enjoy this list of tools with short instructions.
Only place you hear the term Activate is in a good high end Deep Cycle Battery is when the batteries are shipped dry, and the acid is shipped in a different container. So in order to ACTIVATE a dry charged battery is to put the acid in, and then charge at 16 volts until charge current stops to Activate the battery. They do that mostly with Dealers.
Using the electrolyte/acid bottle that you purchased along with the battery, place the container upright on a flat surface. Carefully cut off the tip of the bottle’s spout and attach the short tube. Caution: Do not squeeze the bottle when cutting the fill tip. Do not smoke when activating a battery or handling battery acid.
So in order to ACTIVATE a dry charged battery is to put the acid in, and then charge at 16 volts until charge current stops to Activate the battery. They do that mostly with Dealers. The battery manufacture sends them dry charged batteries, so they can be Activated quite some time later. It extends the shelf life.