Tip1: If a capacitor has long enough leads exposed on the front side of the board, you can cut the capacitor off leaving the old leads and solder the new capacitor to the old leads. This method is even faster. See the last picture for an example. Tip 2: You should replace all the electrolytic capacitors, not just the visibly bad ones.
Desolder Capacitor Leads: Apply the soldering iron to each lead of the faulty capacitor, melting the solder joints to facilitate removal. Use a desoldering pump or solder wick to remove excess solder and free the capacitor leads from the circuit board.
Hot melt glue the new capacitor to the top of the board, the jumpers should remain twisted. Tip1: If a capacitor has long enough leads exposed on the front side of the board, you can cut the capacitor off leaving the old leads and solder the new capacitor to the old leads. This method is even faster. See the last picture for an example.
decrease diameter of the capacitor, and the obvious idea is to remove sleeve off it, it must save several tenths of the millimeter. Is the second option a good idea from your experience, or I would better work on casing? Update: thank you for suggestions so far.
Prepare Soldering Equipment: Heat up the soldering iron to the appropriate temperature for desoldering electronic components. Desolder Capacitor Leads: Apply the soldering iron to each lead of the faulty capacitor, melting the solder joints to facilitate removal.
Solder Capacitor Leads: Securely solder the capacitor leads to the circuit board, applying solder to create reliable electrical connections. Avoid excessive heat and solder to prevent damage to the capacitor or surrounding components.