In trying to measure the current output from a solar panel I've inadvertently short circuit the panel. Did I damaged the panel? How can I test if everything is ok? Does it still produce voltage when light is shone on it? I think the is high enough that it can't be damaged by short circuit. In fact, solar cells are rated by their .
If you connect both ends of your solar panel you will get a short circuit connection. Now put your solar panel under light and take a clamp-on meter. Set it to DC amps and use it on the wire you just connected. And soon you will have a reading and that exactly is the short circuit current of your panel.
A solar panel is rated by its short circuit current and was likely shorted during testing. If your panel was damaged after you shorted it, it likely means that the panel itself was defective in some way. If you’re worried about damaging or overloading your solar panels, here are some common issues to educate yourself on:
Short Circuit is not a natural situation and is only done for short circuit analysis. Get rid of the short circuit as soon as you finished your tests. Be careful of Radiation and Temperature. Most solar module can take 1000 W/sq.cm radiation. Be sure your weather is compatible. And always avoid high temperatures.
If you’re asking about short-circuiting any electronic device, you’re probably worried that you’ve damaged your device in some way. A short circuit happens when an excessive current runs through an unintended path – you overload the system. Yes, you can short a solar panel, but you likely won’t cause damage to the panel in this way.
Don’t leave your panel short for a long duration. Short Circuit is not a natural situation and is only done for short circuit analysis. Get rid of the short circuit as soon as you finished your tests. Be careful of Radiation and Temperature. Most solar module can take 1000 W/sq.cm radiation. Be sure your weather is compatible.
This circuit is a little different than the circuits that use the solar cell for a dark detection; this circuit uses a photo resistor for the dark sensor in place of the solar cell. Now the diode is placed right after the solar cell so Q1 and Q2 are …