1. Soldering irons are hot and will burn you if you are not careful. If you do not know how to solder you will need to learn how to first before attempting this project. 2. You need to have and understanding of basic electricity before attempting to work with solar panels. If you do not have this understanding have some one help you that does.
Moving from top to bottom, use your soldering iron and start soldering the tab wire down. Don't let your iron set in one place to long, you will burn the solar cell. You will need to move your holding tool around as you move the iron down, don't let the tab wire move. Hold the tab wire down until the solder cools. 5.
The first jig is to hold the solar cells while soldering. I made this from a piece of scrap wood and some small nails. I laid out a few of the solar cells on the board and marked places to put the nails. Make sure you put the nails in places that when you are soldering that they do not get in the way of your solder iron.
A normal pigtail joint used on indoor wire connections is unsuitable for joining solar cable ends. The joint must be mechanically crimped and sealed with antioxidant grease and then sealed to prevent oxidation or moisture ingress.
It has been proven that a properly crimped MC-4 connection is superior to a soldered connection. The solar cable connection must be: Solar cables and connections to the solar panel array need to withstand the onslaught of nature for a minimum of thirty years, the expected lifetime of the solar panels.
Strip the protective sleeve from both cable ends, allowing a sufficient length to fit halfway into the copper cable connector. Insert the exposed stranded copper solar wire halfway into one end of the cable connector and securely crimp the cable connector over the wire end.
As the title says this instructable demonstrates how to solder individual solar cells together in preparation for building a solar panel. First i need to give a few disclaimers: 1. Soldering irons are hot and will burn you if you are not careful. …