The lead acid battery is most commonly used in the power stations and substations because it has higher cell voltage and lower cost. The various parts of the lead acid battery are shown below. The container and the plates are the main part of the lead acid battery.
The equation should read downward for discharge and upward for recharge. The battery which uses sponge lead and lead peroxide for the conversion of the chemical energy into electrical power, such type of battery is called a lead acid battery. The container, plate, active material, separator, etc. are the main part of the lead acid battery.
The construction of a lead acid battery cell is as shown in Fig. 1. It consists of the following parts : Anode or positive terminal (or plate). Cathode or negative terminal (or plate). Electrolyte. Separators. Anode or positive terminal (or plate): The positive plates are also called as anode. The material used for it is lead peroxide (PbO 2).
Construction, Working, Connection Diagram, Charging & Chemical Reaction Figure 1: Lead Acid Battery. The battery cells in which the chemical action taking place is reversible are known as the lead acid battery cells. So it is possible to recharge a lead acid battery cell if it is in the discharged state.
The following symbols are being used on all batteries and mean the following: Batteries contain Sulphuric Acid which may leak for various reasons. Also acid may be given off as droplets and/or spray/mist during recharge.
Following are some of the important applications of lead – acid batteries : As standby units in the distribution network. In the Uninterrupted Power Supplies (UPS). In the telephone system. In the railway signaling. In the battery operated vehicles. In the automobiles for starting and lighting.