To do this wiring, make two sets of PV panels and connect them in series. Then, connect the two sets of series-connected solar panels in parallel to the charge connector. This solar system wiring diagram depicts an off-grid scenario where the solar panels are series wired.
Wiring solar panels in series is arguably the easiest of the three methods. In series wiring, the positive of one panel connects to the negative of the next, and so on. This creates a string of panels with a negative wire at the beginning and a positive wire at the end. However, wiring in series is not always as straightforward as it seems.
Connect the negative terminal of the first panel and the positive terminal of the second panel and connect to the corresponding terminals in solar regulator’s input. The solar regulator will detect the panels and start to charge the battery during sunlight. Wiring solar panels in parallel or series doesn’t have to be an either/or proposition.
Pretty much every single solar panel you pick up is going to come with two wires hanging off the back of it: one positive and one negative. It sounds straightforward, but wiring panels can get a bit more complicated when you start to consider the total size of your solar array (the total grouping of all of your solar panels).
The next method of wiring solar panels is in parallel. In this configuration, all the positive ends are connected together, and all the negative ends are connected, maintaining the voltage but adding up the current. For our demonstration, we’ll only be able to use two panels due to the short circuit current of our panels (9.4A each).
Wiring solar panels together can be done with pre-installed wires at the modules, but extending the wiring to the inverter or service panel requires selecting the right wire. For rooftop PV installations, you can use the PV wire, known in Europe as TUV PV Wire or EN 50618 solar cable standard.