Personally, I always make sure that anything connected to a lead acid battery is properly fused. The common rule of thumb is that a lead acid battery should not be discharged below 50% of capacity, or ideally not beyond 70% of capacity. This is because lead acid batteries age / wear out faster if you deep discharge them.
Lead acid is sluggish and cannot be charged as quickly as other battery systems. Lead acid batteries should be charged in three stages, which are constant- current charge, topping charge and float charge.
A lead acid battery consists of electrodes of lead oxide and lead are immersed in a solution of weak sulfuric acid. Potential problems encountered in lead acid batteries include: Gassing: Evolution of hydrogen and oxygen gas. Gassing of the battery leads to safety problems and to water loss from the electrolyte.
The charge time of a sealed lead acid battery is 12–16 hours, up to 36–48 hours for large stationary batteries. With higher charge current s and multi-stage charge methods, the charge time can be reduced to 10 hours or less; however, the topping charge may not be complete.
Ideally you can configure the cut-off coltage, such as with the depicted unit. So many lead acid batteries are 'murdered' because they are left connected (accidentally) to a power 'drain'. No matter the size, lead acid batteries are relatively slow to charge. It may take around 8 - 12 hours to fully charge a battery from fully depleted.
The battery may also fail as an open circuit (that is, there may be a gradual increase in the internal series resistance), and any batteries connected in series with this battery will also be affected. Freezing the battery, depending on the type of lead acid battery used, may also cause irreversible failure of the battery.
OverviewVoltages for common usageHistoryElectrochemistryMeasuring the charge levelConstructionApplicationsCycles
IUoU battery charging is a three-stage charging procedure for lead–acid batteries. A lead–acid battery''s nominal voltage is 2.2 V for each cell. For a single cell, the voltage can range from 1.8 V loaded at full discharge, to 2.10 V in an open circuit at full charge. Float voltage varies depending on battery type (flooded cells, gelled electrolyte, absorbed glass mat), and ranges from 1.8 V to 2.27 V. Equalization voltage, and charging voltage for sulfated c…