The lead acid battery is most commonly used in the power stations and substations because it has higher cell voltage and lower cost. The various parts of the lead acid battery are shown below. The container and the plates are the main part of the lead acid battery.
The equation should read downward for discharge and upward for recharge. The battery which uses sponge lead and lead peroxide for the conversion of the chemical energy into electrical power, such type of battery is called a lead acid battery. The container, plate, active material, separator, etc. are the main part of the lead acid battery.
The construction of a lead acid battery cell is as shown in Fig. 1. It consists of the following parts : Anode or positive terminal (or plate). Cathode or negative terminal (or plate). Electrolyte. Separators. Anode or positive terminal (or plate): The positive plates are also called as anode. The material used for it is lead peroxide (PbO 2).
Utilizing lead alloy ingots and lead oxide, the lead battery is made of two chemically dissimilar lead-based plates immersed in a solution of sulphuric acid. How do you maintain a lead-acid battery? Apply a fully saturated charge of 14 to 16 hours to keep lead acid in good condition.
The container stores chemical energy which is converted into electrical energy by the help of the plates. 1. Container – The container of the lead acid battery is made of glass, lead lined wood, ebonite, the hard rubber of bituminous compound, ceramic materials or moulded plastics and are seated at the top to avoid the discharge of electrolyte.
A completely charged lead-acid battery is made up of a stack of alternating lead oxide electrodes, isolated from each other by layers of porous separators. All these parts are placed in a concentrated solution of sulfuric acid.