They may not understand the need to have the water temperature set at a safe level. Split solar hot water systems are designed to have the solar collectors (either flat plate or evacuated tubes) on the roof and the storage cylinder installed at ground or floor level.
Split solar hot water systems are designed to have the solar collectors (either flat plate or evacuated tubes) on the roof and the storage cylinder installed at ground or floor level. These diagrams are intended to give an overview of the operation principle of a split solar hot water system. They are not intended as an installation guide.
When temperature sensors that control a solar hot water system experience malfunctions, they can lead to water coming out of taps and showers at different temperatures. These malfunctions, whether due to defective temperature sensors or electronic control system glitches, can result in water being either excessively heated or heated enough. 10.
The following diagrams illustrates the Split Solar Hot Water System set up for both the Electric and Gas boost. If the valve leaks continuously, try easing the valve gear for a few seconds. This may dislodge any foreign matter and alleviate the problem. If this does not alleviate the problem contact Rinnai.
See entry under 'Insufficient hot water'. If the solar control unit is switched off there will be no solar pre-heating of water resulting in the water being heated entirely by electricity or gas' boosting'. Check the power outlet for the solar control unit is switched on. See entry under 'Insufficient hot water'.
Repainting the panels with heat and UV-resistant paint is necessary in case of coating or absorber paint erosion. Making a small weep hole at the base of the panel is recommended to deal with the condensation problem on the solar glass. Also, check out How to Turn Off a Solar Hot Water System 5. Stinking Hot Water